INSTALLATION GUIDE FOR OPTION I

I. Pre-Requirement

This option requires a static IP address for the device. If you only have a static IP address for the router, you still can chose this option. Map port 4370 to the private IP address assigned to the device (in your router configuration). If you have firewall installed, open the port 4730 both in and outbound.

II. Installation and Configuration Time Terminal (Bio-Clock)

1. Mount the bio-clock.

2. Set up IP address for the device
    a. Power on the device
    b. Push MENU button
    c. Select Options then push OK button
    d. Select Comm Opt then push OK button
    e. Select IP Addr then push OK Button
    f. Enter IP address and then push OK button
    g. Select Ethernet and make Ethernet option is set to yes
    h. Then push ESC button
    i. Push OK button to save
    j. Push ESC until back at the main screen

3. Repeat steps 1, 2 to install more time terminal

4. After the device is setup, notify GHG with the IP addresses assigned to the  device. GHG will test the connection to the device(s) and setup the services.

III. Enroll User into Time terminal

1. Power on the device

2. Push MENU button

3. Select User Manage then push OK button

4. Select Enroll User then push OK button

5. Select Enroll FP then push OK button

6. Push button OK for new enroll

7. Push button OK for new enroll at the given enroll number

8. Then place finger on the fingerprint sensor three times

9. Push button OK to save

10. Push ESC button to return